Matikgate BOLT Manual De Usuario/Instalador página 65

RACK INSTALLATION
EN
1-2mm
Make sure that between the pinion and the rack there is a gap of at least 1-2mm. If
necessary, adjust the height of the motor or rack.
INSTALLATION LIMIT SWITCHS
right
left
With the rack already installed, with the gate closed, install the limit switch plate on the
rack. The plate must activate the motor limit switch. Tighten the screws provided until
they touch the rack.
With the gate open, install the second limit switch plate, repeating the same process.
65
MATIKGATE AUTOMATION