Matikgate BOLT Manual De Usuario/Instalador página 69

Press ENTER button shortly to enter the basic menu.
oL
appears on the display, with the UP/DOWN buttons it is possible to select other functions from this
menu. To exit the menu, select
Shortly press ENTER
Exit
oL
OPERATING MODE
St
Step by step mode: inputs 3 and 4 function as start and pedestrian.
At
Step by step mode with automatic closing: inputs 3 and 4 fucntion as start.
cd
Condominium mode: entrances 3 and 4 function as start and pedestrian.
oc
Opening/Closing mode: inputs 3 and 4 function as opening and closing.
oA
Opening/Closing mode with automatic closing: inputs 3 and 4 functions as opening and closing.
EH
To exit this menu, select
Lc
LEARNING TRANSMITTERS:
Lc
Select and press ENTER, with the UP/DOWN buttons select the sub menu.
c1
Transmitter learning. Select this menu and transmit to record a start/open command.
c2
Transmitter learning. Select this menu and transmit to record a pedestrian/close command.
c3
Transmitter learning. Select this menu and transmit to record a courtesy light command.
rA
Delete all transmitters. Select this menu and select
EH
To exit this menu, select
Lt
LEARNING WORKING TIME
Lt
in the base menu and press ENTER, after selecting the learning mode with the UP/DOWN buttons.
Select
The door closes to the close limit switch, then opens to the open limit switch and finally closes once.
Attention: if you are not sure which direction the door is facing, place it in the fully closed position before starting programming,
the board will assume the limit switch as the closing side and automatically manage the motor direction (see menu
vanced menu). To interrupt the learning procedure, toggle the input stop.
SP
TEMPO DE PAUSA (Fecho automático)
Use the UP/DOWN buttons to set the pause time between 0 and 99 seconds. Press ENTER to confirm.
EH
To exit this menu, select
F5
MAXIMUM SPEED
Use the UP/DOWN buttons to set the maximum speed between 3 and 10. Press ENTER to confirm.
EH
To exit this menu, select
dM
PRESENT MAN MODE - It is possible to control each motor in present man mode. Press UP and DOWN buttons to select
one of the following items:
oP
Motor opening.
c1
Motor closing.
EH
Exit.
Press and hold the ENTER button to start the selected engine in present man mode.
BASE MENU ADJUSTMENT
EH
or press UP and DOWN at the same time.
Operating mode
Learning commands
Learning working time
Pause time
(automatic closing)
Set the maximum engine
speed
Present man mode
or press UP/DOWN at the same time.
or press UP/DOWN at the same time.
or press UP/DOWN at the same time.
or press UP/DOWN at the same time.
YS
(yes) in the next menu.
EN
Gd
in ad-
69
MATIKGATE AUTOMATION