Publicidad
Idiomas disponibles
Idiomas disponibles
Do not apply pressure to or stab at the touch button, a light touch using a bare finger is
BATTERY
sufficient. The command pulse is sent when the finger releases the button.
2.8) Battery status
BATTERY
The battery is equipped with LED indicators that indicate the remaining battery life at any time
by pressing the adjacent button (P) (Ref. to Fig. 5):
4 LEDs illuminated: fully charged
2 LEDs illuminated: 50 % capacity
1 LED flashing: minimum charge, replace the battery.
With the battery inserted into the tool, the remaining bat-
tery life can also be checked on the display, via touch but-
RESET
ton selection (Ref. to § 4).
SW:S1J41413
The screen shown alongside indicates that the battery voltage has
dropped below a minimum safety threshold; under these conditions
the tool will not start, and it is necessary to recharge or replace the battery.
The approximate time to fully recharge a battery is about 100 minutes.
LED
N
OFF
2.9) Using the battery charger
Carefully follow the instructions in the battery charger user manual.
3 SEC.
LED
ON
n
3. MAINTENANCE
n
The tool is robust, completely sealed, and requires very little daily maintenance. Compliance with
the following points, should help to maintain its optimum performance:
r
3.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any residue,
si
especially close to pivots and moveable parts.
i
Do not use hydrocarbons to clean the rubber parts.
3.2) Storage case
When not in use, the tool should be stored and transported in the plastic case, to prevent damage.
The case, type VAL P36, is suitable for storing the tool, the accessories and up to 7 die sets and pre-
prepared compression connectors.
VAL P36: Size 500x480x128 mm (19.7x18.9x5.0 inches). Weight 3,1 kg (6.8 lbs).
9
F
= 125.2 kN
m
Fp = 94.5 kN
13001
F
= 14.07 ton
m
Fp = 10.61 ton
P
= 692 bar
m
F
= 125.2 kN
m
Pp = 522.3 bar
F
= 102.3 kN
p
P
= 692 bar
m
P
= 10037 psi
m
P
= 565 bar
p
Pp = 7575 psi
max.
BATTERY
BATTERY
1000
-12000
B1350
13AB485
LED
ON
LED
OFF
3 SEC.
ERROR
F
m
F
p
P
m
P
p
001
002
003
004
F
= 125.2 kN
m
OK
P
= 692 bar
m
OK
min.
BATTERY
= 125.2 kN
F
m
= 102.3 kN
P
= 692 bar
m
= 565 bar
max.
BATTERY
BATTERY
BATTERY
BATTERY
LED
ON
LED
OFF
RESET
SW:S1J41413
LED
OFF
3 SEC.
LED
ON
= 125.2 kN
OK
= 692 bar
OK
min.
13001
Publicidad
