Troy-Bilt TB144 Manual Del Operador página 15

CAUSE
On!Off control inthe STOP
p osition
Primer bulb wasn't pressed enough
Fouled spark plug
Engine is flooded
CAUSE
Air filter is plugged
ACTION
Turn On/Off control to ON
Press primer bulb fully and slowly 10 times
Replace or clean the spark plug
Pull starter rope repeatedly with throttle control fully
engaged and with the choke lever in Position 3
ACTION
Replace or clean the air filter
Improper carburetor adjustment
CAUSE
Old or improperly mixed fuel
Dirty air filter
Cultivator tines bound with dirt or grass
Adjust according to the Carburetor Adjustments section or take
to an authorized service dealer for an adjustment
ACTION
Drain gas tank and add fresh fuel
Clean or replace the air filter
Stop the unit, switch the On/Off Stop Control to STOP, clean
and remove any debris binding the tines
CAUSE
Old or improperly mixed fuel
Fouled spark plug
Low power
CAUSE
Oil fill plug/dipstick loose or missing o-ring
CAUSE
Spark plug gap is too small/close
ACTION
Drain gas tank and add fresh fuel
Replace or clean the spark plug
Rocker arm clearance adjustment (see page 18)
ACTION
Tighten oil fill plug/dipstick, replace o-ring
ACTION
Adjust gap to 0.025"
If further assistance is required, contact your authorized service dealer.
15