Accessories List
① ② ③ ④ ⑤
X1
Bolt 1-5
Pin
X2
Washer 10*16
Flat screw 4*12
Installation Steps
※ Front wheel installation
A
B
C
06
X3
X2
Washer 4*12
Washer 10*20
X8
X4
Round head
Round head
screw 4*12
screw 4*16
1.①Connect the Φ10*20mm washer
to the steering axle, and then insert
it into the body frame. ②Insert the
steering connector (mark facing
downward) into the steering axle,
and fix it with 4*16mm round head
screw and 4*12mm washer.
2.Insert the Φ10*16mm washer into
the front axle as shown, and then
into the hole of the steering part.
This side of the wheel
faces outward
X5
3.Insert wheels and Φ
10*20mm washers into the
front axle as shown.
X2
This side of the wheel faces outward
1.Put the Φ10*20mm washer,
wheel and wheel sleeve on the
rear axle in turn, and then
insert them into the rear of
the car body as shown.
3.Insert the Φ10*20mm
washer, and fix the wheel with
the pin.
4.Insert the pin into the front
axle to fix the wheel as shown.
※ Rear wheel installation
This side of the wheel faces outward
2.Insert the driving wheel into
the rear axle, and snap it into
the motor slot.
4.Install 4 decorative rings as
shown.
07