Sony Trinitron GDM-FW900 Manual De Instrucciones página 14

Restoring the color from the EASY or sRGB menus
(IMAGE RESTORATION function)
The colors of most display monitors tend to gradually lose brilliance
over several years of service. The IMAGE RESTORATION feature
found in the EASY and sRGB menus allows you to restore the color
to the original factory quality levels.
1 Move the joystick left or right to select EASY or
sRGB mode.
2 First move the joystick up or down to select
tSd (IMAGE RESTORATION). Then move the
joystick to the right.
The picture disappears while the color is being restored (about
2 seconds). After the color is restored, the picture reappears
on the screen again.
Notes
• Before using this feature, the monitor must be in normal operation
mode (green power indicator on) for at least 30 minutes. If the monitor
goes into power saving mode, you must return the monitor to normal
operation mode and wait for 30 minutes for the monitor to be ready.
You may need to adjust your computer's power saving settings to keep
the monitor in normal operation mode for the full 30 minutes. If the
monitor is not ready, the following message will appear.
COLOR
EASY EXPERT sRGB |
■ 5000K
6500K
■ 9 3 0 0 K
□
IB
_ _1 □
5 0 0 0 K
tSa 1 MAGE
RESTORATION
© AVAILABLE
AFTER WARM UP
• The monitor may gradually lose its ability to perform this function due
to the natural aging of the picture tube.
Adjusting the quality of the picture
(SCREEN)
The SCREEN settings allow you to adjust the quality of the
picture by controlling the moire and landing.
• If the color is irregular at the comers of the screen, adjust the
landing.
• If elliptical or wavy patterns appear on the screen, cancel the
moire.
The CANCEL MOIRE and MOIRE ADJUST settings are stored
in memory for the current input signal. All other settings are
stored in memory for all input signals.
1 Press the joystick.
The main MENU appears on the screen.
2 Move the joystick to highlight (HD SCREEN and
press the joystick again.
The SCREEN menu appears on the screen.
3 First move the joystick up or down to select the
desired adjustment item. Then move the joystick left
or right to make the adjustment.
Select To
□
LANDING
reduce any color irregularities in the
screen's top left corner to a minimum.
□
LANDING
reduce any color irregularities in the
screen's top right corner to a
minimum.
□
LANDING
reduce any color irregularities in the
screen's bottom left comer to a
minimum.
□
LANDING
reduce any color irregularities in the
screen's bottom right corner to a
minimum.
o
CANCEL MOIRE*
turn the moire cancellation function
ON or OFF.
•fitiir (MOIRE ADJUST) appears in
the menu when you select ON.
MOIRE ADJUST
adjust the degree of moire
cancellation until the moire is at a
minimum.
* Moire is a type of natural interference which produces soft, wavy lines
on your screen. It may appear due to interference between the pattern
of the picture on the screen and the phosphor pitch pattern of the
monitor.
Example of moire
Note
The picture may become fuzzy when CANCEL MOIRE is set to ON.
14