Identifying parts and controls
See the pages in parentheses or further details.
Front
Rear
To use the control stick
This monitor has a cylindrical swivel control stick. To operate the
controls, turn the knob on the left side downward to expose the control
buttons. When the control buttons are not needed, turn the knob up to
hide the control buttons.
When not using
When using
[T|
RESET (reset) button (page 16)
This button resets the adjustments to the factory settings.
[2] ASC (auto sizing and centering) button (page 9)
This button automatically adjusts the size and centering of the
picture.
[3] INPUT (input) switch (page 9)
This switch selects the HD 15 or BNC video input signal.
[4] Joystick (page 11)
The joystick is used to display the menu and make
adjustments to the monitor, including brightness and contrast
adjustments.
[5] ® (power) switch and indicator (pages 7,16, 20)
This button turns the monitor on and off. The power indicator
lights up in green when the monitor is turned on, and either
flashes in green and orange, or lights up in orange when the
monitor is in power saving mode.
[6] AC IN connector (page 7)
This connector provides AC power to the monitor.
[7] USB (universal serial bus) downstream connectors
(page 8)
Use these connectors to link USB peripheral devices to the
GB
[8] USB (universal serial bus) upstream connector
(page 8)
Use this connector to link the monitor to a USB compliant
computer.
[9] Video input 1 connector (HD15) (page 6)
This connector inputs RGB video signals (0.700 Vp-p,
positive) and sync signals.
©®®@®
®(D(D®(6)
Pin No.
Signal
1
Red
2
Green
(Composite Sync
on Green)
3
Blue
4
ID (Ground)
5
DDC Ground*
6
Red Ground
7
Green Ground
Pin No.
Signal
8
Blue Ground
9
DDC + 5V*
10
Ground
11
ID (Ground)
12
Bi-Directional
Data (SDA)*
13
H. Sync
14
V. Sync
15
Data Clock
(SCL)*
* DDC (Display Data Channel) is a standard of VESA.
01 Video input 2 connector (BNC) (page 6)
This connector inputs RGB video signals (0.700 Vp-p,
positive) and sync signals.
5