BGS technic 9069 Manual De Instrucciones página 6

POINTER ZERO POSITION
Due to transport or other adverse circumstances, it may happen that the
pointer of the dial gauge is not in zero position.
To adjust the dial gauge back to zero, please proceed as follows.
Remove the rubber protector.
Pull the top forward and finally down side over the connector.
Remove the plastic glass.
Take a slotted screwdriver and pry the glass off the housing.
Outside the edge of the glass there are some slots for attaching the slot
screwdriver.
Take a slot screwdriver and turn the adjusting screw in the direction in
which the pointer must be re-adjusted. In the shown example, the
adjustment screw must be turned clockwise.
Mount plastic glass and rubber protector.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed