HIKOKI DH 36DMA Instrucciones De Manejo página 11

USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
NAMES OF PARTS (Fig. 1–Fig. 22)
Drill bit
Stopper
Selector lever
Switch trigger
Handle
Nameplate
RFC indicator lamp
Rotation speed
selector switch
Display lamp
Battery
Tail cover
Housing
Motor
Side handle
Grip
Front cap
Stopper lever
Latch
Charge indicator lamp
Remaining battery
indicator switch
Remaining battery
indicator lamp
Display panel
Grease
Wing bolt
Band
Handle bolt
Mount
Band attachment area
Taper shank adapter
Drill bit (Taper shank)
Cotter
Core bit shank
Core bit
Guide plate
Center pin
Core bit tip
Battery sliding
grooves
Terminal
Rubber cover
USB port
USB cable
11
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
DH36DMA: Cordless Rotary Hammer
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in accordance
with national law, electric tools that have
reached the end of their life must be collected
separately and returned to an environmentally
compatible recycling facility.
Direct current
V Rated voltage
n
No-load speed
0
min Oscillation per minute
-1
Bpm Full-load impact rate
φ
Drilling diameter, max.
max
Weight*
(According to EPTA-Procedure 01/2014)
kg
Drill bit
Core bit
Adjustment of the tool position function
Hammering only function
Rotation and hammering function
Switching ON
Switching OFF
Rotation speed selector switch
Display lamp
Ls
Low speed / impact rate
Hs
High speed / impact rate
Disconnect the battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
English