HIKOKI DH 3628DA Instrucciones De Manejo página 11

REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100 Wh are considered to be in the freight classifi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
Wh
2 to 3 digit number
USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
NAMES OF PARTS (Fig. 1–Fig. 25)
Handle
Switch trigger
Pushing button
Housing
Side handle
Depth gauge
Drill bit
Front cap
Grip
Name plate
Change lever
Gear cover
Level LED
Motor
LED light
Battery
Display panel
Changeover switch
Display lamp
Auto stop lamp
Level LED switch
Nozzle
Depth adjustment
button
Nozzle adjustment
button
Dust housing
Dust box
Dust box latch (both
side)
11
English
Filter
Button
Latch
Charge indicator lamp
Grease
Pushing button
(Change lever)
Cold chisel
Bit holder ass'y
Chuck holder ass'y
Auto stop lamp: Blinks
Auto stop lamp: Lights
Level LED: Green
lights
Level LED: Green
blinks
Level LED: Red lights
Gravity direction
UP
DOWN
LEFT
RIGHT
Battery sliding grooves
Terminal (Product)
Air gun
Terminal (Battery)
Sliding grooves
Rubber cover
USB port
USB cable