LiftMaster myQ Business CAP2D Manual De Instalación página 6

INTRODUCTION
Specifications
INTRODUCTION
CAP2D Capacity
CAP2D Operating Temperature Range
CAP2D Operational Humidity
Storage and Shipping Temperature Range
Wiegand Inputs (2)
2 Primary and 2 Auxiliary Relay Outputs
INTRODUCTION
Accessory Compatibility
Network Compatibility
Wire Specification
PoE Supply Connector Configuration
*NOTE: Only 26-bit is UL compatible.
INTRODUCTION
Electrical Ratings
POWER IN
Auxiliary Input
Power Over Ethernet
INTRODUCTION
POWER OUT
Relays (wet)
Wiegand Readers
Relays (dry-inductive)
INTRODUCTION
NOTE: IP Door Controller is to be connected to UL Listed
Commercial 294 or 603 Power Supply for Auxiliary, or UL Listed
294/294b PoE Listed power supply for Power over Ethernet.
PRE-INSTALL WIRING
PRE-INSTALL WIRING
Resident Capacity: 25,000 / Local Event History: 6,000
-31°F to 150°F (-35°C to 66°C)
5% to 95% non-condensing
-40°F to <185°F (-40°C To <85°C)
*26-Bit SIA Standard, 30-Bit Sentex, 32-Bit Mifare, 37-Bit HID with Facility Code,
37-Bit Transcore. Also supports ASCII for Wiegand keypads.
SPDT
PRE-INSTALL WIRING
Refer to the accessory page for compatible accessories
10/100 Ethernet
RJ-45 Wired Ethernet
Alternative B
PRE-INSTALL WIRING
VOLTAGE POWER (MIN)
12 VDC 13 Watts
44-57 VDC 13 Watts
PRE-INSTALL WIRING
VOLTAGE CURRENT (MAX)
12 VDC 750mA (combined)
12 VDC 750mA (combined)
30 VDC (max) 2,000mA
PRE-INSTALL WIRING
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
6
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL