Publicidad
CARRY-BIKE
LIMIT
30°
30°
EN
Read the following instructions and warnings carefully; failure to observe these installation and usage instructions
as well as the laws for driving in the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility. Before installation, ensure compatibility with the vehicle on which the
product must be installed.
In the event of an accident involving the vehicle and/or the product, ensure that the product has not been
damaged. In the event of damage, contact your local retailer before moving the vehicle. Fiamma declines every
responsibility for any modification of the product that may cause damage and/or injury to things and people.
Checking that the wall/rear door is sufficiently solid and suitable for guaranteeing the resistance of the anchoring
points is always mandatory. If not, strength and compliance with the maximum load indicated in the instructions
are not guaranteed and it will be necessary to reinforce these points.
After having positioned the Carry-Bike on the rear axle of the vehicle, the normal weight distribution on both axles
would be modified. This variation must not exceed the maximum permissible axle load.
Never exceed the maximum permitted length and the total weight of the full-load vehicle.
Make sure that loading occurs following a correct weight distribution; it must be uniformly distributed (the
heaviest bike must be placed near the wall of the vehicle) to ensure better stability.
Always give warnings about the presence of the Carry-Bike on your vehicle, using a clearly signal for leaning
loads and, in case of limited rear visibiliy, use the additional rear-view mirrors.
Take into account the presence of the Carry-Bike, paying attention during driving and expecially during reversing
manoeuvres, particularly if you have parking assist system. Always comply with speed limits and the Highway
Code. The speed should always be suitable to traffic conditions and towed load. In case of use of the
bike carrier with tow make sure that the tow hook is always accessible and the corner mobility of the tow is
11
guaranteed (volume measuring din 74058).
Publicidad
