Pioneer KEH-P8600R Manual De Instalación página 8

1. Install the bracket to the mounting base. (Fig. 17)
°-— Screws (3 x 10 mm)
Bracket
Mounting base
2. Install the mounting base to the vehicle.
Eg. 1: Installation with double-sided tape. (Fig. 18)
Precaution:
* Before using double-sided tape, clean off any dirt on the surface to which the double-sided tape is
to be attached.
)
Passenger seat
Eg. 2: Installation with the screws. (Fig. 19)
Precaution:
* Before drilling any mounting holes. confirm that the screws will not interfere with any of the cars
operating systems (such as the fuel line, brake lines. electrical wiring, etc.).
Drill holes 2 - 2.5 mm in diameter.
Screws (4 x 12 mm)
Passenger seat
Fig. 19
installation Using the Mounting Base and the "AD-R60"
Install the bracket (A) of the "AD-R60" to the mounting base. (Fig. 20)
= Screws (3 x 10 mm)
-~ Bracket (A)
(Supplied with the "AD-R60",)
Mounting base
Fig. 20
Note:
* See the "AD-R60" instruction manual for instructions on installing the "AD-R60" to the vehicle.