Connecting the control system
The OASE Eco Control control unit (accessory) is required for operating the pump.
Alternatively, the pump can be integrated in an OASE Control network. For information on this
topic, visit www.oase.com.
For further information, refer to the operating manual for the accessories.
Connecting and disconnecting the OASE Control plug connection
NOTE
The unit will be damaged, if water enters the plug connector.
• Connect the plug connector or place the protective cap on the plug connector.
– Ensure that the rubber seal is clean and fits exactly. If the rubber seal is damaged, it must
be replaced.
– Secure the plug connector or the protective cap with the two screws.
EN
AMX0158
EGC0009
PLX0004
29