Joie litetrax 3 Manual De Instrucciones página 8

Use Accessories
Accessories may be sold separately or may not be available depending on region.
Use with Joie Child restraint
When using with Joie child restraint gemm, i-snug 2, please refer to the following instructions.
The stroller can accept Joie child restraint (Gemm and i-Snug 2) attachment directly without the adapters. Please
refer to the section "Use with Strollers" in the child restraints' manuals.
!
If you have any problems about using the infant child restraint, please refer to their own instruction manuals.
!
Please don't fold stroller when attaching the child restraint.
Use Footmuff
The soft footmuff can provide your child with a warm and comfortable environment.
Assemble the footmuff by following these steps.
1. Place the footmuff over the seat after unziping it, thread the shoulder harnesses, waist harnesses and crotch
harness through respective slots.
25
2. Thread loop fastener on the top of the footmuff through the backrest, and then stick it to the hook fastener.
3. Place baby into the footmuff, lock the safety buckle, and then rezip the footmuff.
The assembled footmuff is shown as
27
Use Rain Cover
To assemble the rain cover, place it over the stroller, and then attach the 8 pairs of hook and loop fasteners on the
rain cover.
28
!
Before using the rain cover, please make sure the backrest has been adjusted to the lowest position and the
infant child restraint has been fastened.
!
When using the rain cover, please always check its ventilation.
!
When not in use, please check that the rain cover has been cleaned and dried before folding.
!
Do not fold the stroller after assembling the rain cover.
!
Do not place your child into the stroller assembled with rain cover during hot weather.
Care and Maintenance
!
Removable seat pad may be washed in cold water and drip-dried. No bleach.
!
To clean stroller frame, use only household soap and warm water. No bleach or detergent.
!
From time to time, check your stroller for loose screws, worn parts,torn material or stitching. Replace or repair
the parts as needed.
!
Excessive exposure to sun or heat could cause fading or warping of parts.
!
If stroller becomes wet, open hood and allow to dry thoroughly before storing.
!
If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing machine oil). It is important to get the
oil into the axle and wheel assembly.
24
!
When using your stroller at the beach, completely clean your stroller after use to remove sand and salt from
mechanisms and wheel assemblies.
13
Note
26
14