First Lighting - Palazzetti ECOMONOBLOCCO WT R Manual De Uso Y Mantenimiento

5 Lighting
It is recommended to carry out all the manual operations using the glove supplied.

5.1 First lighting

The first few ignitions (after installation or at the start of the season) must be carried out with reduced
loads (~ 2 kg/h), keeping the product on for at least 4 hours at low rates. Proceed with these feed rates
for at least three days before using the appliance at its full capacity. This will allow for the evaporation
of any moisture accumulated in the refractory elements when not used.
The first time the fireplace is lit, unpleasant odours or fumes may be generated by the evaporation
or drying of the various materials used, and water may seep from the grout. This phenomenon will
gradually disappear.
For this reason during the first lighting it is recommended to maintain the premises well airy.
5.2 Lighting
The fireplace is preferably supplied with well seasoned beech wood, in commercial size of 25, 33 cm. The
recommended humidity is 25%.
Each type of wood has different characteristics that also affect the combustion efficiency.
It is strictly prohibited to use any type of coal, wood treated with protective substances, cardboard and paper.
- Open the sliding door, using the appropriate glove provided, by holding the handle and pushing it upwards
(for the models with manual opening) or by acting on the control panel (for the models with automatic opening).
- Using the cold handle supplied (M) open the primary air adjustment all the way (+) (Fig. 5.2).
- Carefully lay the pieces of wood in the combustion chamber, taking care not to totally cover the slits of the
grid (G) (Fig. 5.2).
- Place a natural fire-igniter on the pile of wood.
- Add on top of the stack strips of wood end crossed between them.
- Light the fire-igniter from above.
- Close the door and make sure it is closed properly.
- Keep the air intake open to ensure a high and bright flame.
- Reduce the air outlet opening using the handle cold (M) (Fig. 5.2) only when a good ember base has formed.
Fig. 5.2
G
Product images are purely indicative
26
M
004778160 - 18/08/2020
-
M
+