Remote Control (Optional) - Palazzetti ECOMONOBLOCCO WT R Manual De Uso Y Mantenimiento

9

Remote control (optional)

9.1 Overview
This device allows you to remotely control the
operating parameters of the Ecomonoblocco.
9.2 Pairing at the control panel
Access the screen Info on the control panel display
and navigate on the screen
Remote: scanning..
Insert the batteries in the remote control
After few seconds the display will change screen, you
will be presented with the following information and the
remote control will be properly paired to the control panel:
Remote: connected! Remote paired to the control panel
Temp [*C]: 26.0 Room temperature detected by the
remote control
Hu [perc]: 34.5 Percentage of humidity detected by
the remote control
Pr [mBar]: 1000 Atmospheric pressure detected by
the remote control
It may be necessary to perform this procedure again in
case the remote control remains outside of the range
of the signal for a long time.
9.3 Keys
1: Switch On / Off (press and hold for about 3 seconds
to perform the desired operation)
2: Key momentarily not enabled
3: Power
4: Ventilation
5: Door opening (where provided)
6: Key momentarily not enabled
7 and 8: Keys to set the parameters
9.4 Changing the power
a) Press key 3, which will light up
b) Press the keys 7 and/or 8 to set the
desired value
9.5 Changing the ventilation
a) Press the key 4 which will light up
b) Press the keys 7 and/or 8 to set the desired
value
9.6 Door opening/closing (where
provided)
a) Press the key 5 which will light up
b) Press the keys 7 and/or 8 to open / close the door
9.7 Reset the remote control
If you need to reset the remote back into factory
configuration, press simultaneously for about
3 sec. the buttons 1 3 8 on the remote control.
34
004778160 - 18/08/2020
1
C
3
5
7
AAA 1,5 V - 2x
2
4
6
8