Publicidad
Idiomas disponibles
Idiomas disponibles
•
Never immerse the product in water or other liquids.
•
Use the product only in its intended manner. Other use may result in damage to the
product or its surrounding environment.
•
Tighten the screws but do not overtighten them. Overtightening (e.g. by using
a cordless screwdriver) this can cause damage and affect the secure hold of the
screen.
•
Suspended loads must be checked for strength and load-bearing capacity at least
twice a year.
•
Failure to follow the above instructions may result in personal injury and damage
to the product or equipment attached to it. Incorrect installation or use may also
invalidate the
•
warranty may be voided.
•
If you are unsure about the use of the product, please contact your
specialist personnel, your dealer or celexon directly (Web: www.celexon.co.uk, Mail:
info@celexon.co.uk).
•
Technical changes and errors expected.
The manufacturer accepts no responsibility for damage to property or personal
injury, if the screen is used outside the recommended specifications, or in the event of
improper installation. Do not use this screen in the vicinity of heaters or air conditioners.
Also, do not mount the product in direct sunlight or in front of a window. Due to the
temperature-sensitive PVC surface, the projection screen fabric may be permanently
damaged.
We recommend that you wait approx. 2 hours after delivery before installing the
projection screen. This way you will allow the screen to acclimatise, especially when
moving from a cold to a warm environment (or vice versa).
Please avoid any stains on the surface of the screen. These may not be able to be
removed.
•
Note the front and back of the fabric when attaching it.
•
Please check ALL parts for damage or scratches before assembling!
•
The screen may ONLY be assembled on a soft, padded surface. Otherwise the frame
coating may scratch.
•
For permanent flatness, please note the following:
1.
Do not touch the projection surface with your hands
2.
Do not fold the projection surface
3.
Do not paint or write on the projection surface
2
Publicidad
