Celexon HomeCinema Manual De Usuario página 13

STEP 1: ASSEMBLY FRAME
1. Lay out the 4 aluminium struts on a soft surface (2x horizontal & 2x
vertical) parallel to each other in a rectangle (Fig. 3). Push two corner
connectors into each end of a horizontal frame piece and attach the two
vertical frame pieces onto it (Fig. 4, 5 and 6).
2. Slide the remaining
horizontal frame and push them onto the vertical frame as shown in Fig. 7.
(Note: The two corner connectors must be pushed into the vertical
frame at the same time and evenly, so do this step with help from a second
person). Align the frame so that the holes in the corner connectors match
the holes in the frame. Insert the M5x8mm screws into each hole, check
again that the frame is correct and tighten the screws all around (6-8 Nm)
(Fig. 8 and 9).
Fig. 3
Fig. 5
two corner
Fig. 7
C
A
B
Fig. 4
Fig. 6
connectors
Fig. 8
Fig. 9
into the lower
5