Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 2: FABRIC ATTACHMENT
1.
Insert the PVC rods into the fabric pockets. It is recommended to carry out
this procedure with 2 people.
2.
Spread out the fabric (observe the correct side!) and first fasten two
tensioning hooks in each corner of the frame. Tension the fabric only in
all 4 corners at first. Continue all the way round with all the other springs.
(Fig. 10, 11 and 12). Note: When tensioning the springs with the enclosed
tool, always use one hand and pull the spring with the second hand until it
can be hooked into the fabric. Carry out this step in pairs. The fabric may
seem too small, but it must be as you have to put a lot of tension on the
spring to achieve the flatness required.
Fig. 10
3.
Measure the distance between the two hanging points on the frame.
The two wall brackets should each be positioned approx. 50cm from the
outer edge. Mark the measurement on your wall (horizontally) and pre-drill
holes for the wall brackets. Fix the wall brackets with the enclosed mounting
material. Carefully hang the screen into the brackets (Fig. 13 and 14).
Fig. 13
Fig. 14
celexon Europe GmbH | Gutenbergstraße 2 | 48282 Emsdetten | DE
Fig. 11
To mount the frame, two people
should lift it, one on each side. Lift
and hang the frame at the same
time onto the mounting brackets.
This completes the installation.
Fig. 12
6
Publicidad
