STERWINS UP40 Instrucciones De Montaje, Utilización Y Mantenimiento página 203

6. WINTERING & STORAGE
6.1 STORE THE MACHINE
Let the machine cool for hours outside before storing it. Be sure to secure the unit while
transporting (remove the blade). Examine the unit thoroughly for worn, loose or damaged
parts. Clean the product and empty the grass bag before storing.
Only store the machine in a clean, dry, ventilated place with a temperature range of 4°C to
24°C. Cover it in order to provide added protection. Do not expose the product to sunlight. Make
sure the product is always protected from cold and humidity. We recommend using the original
package for storage or covering the product with a suitable cloth or enclosure to protect it
against dust.
6.2 STORE THE LITHIUM BATTERIES
Please make sure that the battery power level is as recommended in the battery instruction
manual. Please refer to the battery instruction manual for further details.
7. MAINTENANCE
7.1 CLEANING
WARNING ! DO NOT HANDLE CUTTING PARTS WITHOUT GLOVES
AS THEY ARE SHARP AND CAN BECOME HOT AFTER USE,
POTENTIALLY CAUSING PERSONAL INJURY.
Cleaning the product : illustration 5.1 to 5.2
Let the machine cool for hours outside before cleaning it. Take the blade out of the blade latch.
Keep all safety devices, air vents, and motor housing free of debris and dirt. Wipe down the
equipment with a cloth. It is highly suggested that you clean the device after every use. Do not
use cleaning agents, as these can attack the plastic and weaken the structural integrity of the
product.
7.2 REPLACEMENT
When servicing, use only identical replacement parts. Use of any other parts may create a
hazard or cause product damage. If you shall replace the cutting blade, make sure that the
following characteristics are the same : same shape, same length, same thickness, same
weight, same material.
The following part of this product may be replaced by the consumer.
→ Blade (90)
Other spare parts are available at an authorised dealer or through our customer service.
Changing the cutting blade : illustration 6.1 to 6.9
Turn the mower onto its side to reveal the underside of the machine. Place a block of wood or a
stop of some kind between the blade and the edge of the deck to prevent the blade from turning
freely. Using a wrench , loosen the blade nut on the bottom of the unit . Remove the blade nut,
the washer, and the blade from the machine.
Put the new blade onto the shaft and replace the blade washer and the blade nut. Tighten the
blade nut. Torque the blade nut to 25-30 N•m. Once the blade is secure, check by hand that
everything rotates as it should.
203
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN