STERWINS UP40 Instrucciones De Montaje, Utilización Y Mantenimiento página 207

7.5 TROUBLESHOOTING
DANGER ! RISK OF INJURY DUE TO ELECTRIC SHOCK.
BEFORE ANY TROUBLE SHOOTING, SWITCH OFF THE PRODUCT.
Problems
Product does
not start
The handle is not
correctly fitted
The mower cuts
unevenly
Mulching is not
done correctly
The mower is
difficult to push
The grass cuttings
are not collected
properly in the
grass box
Probable causes
Battery is not secure
Battery is not charged
Power/speed switch is
in the OFF position
Battery pack not
properly attached
On/off switch not set
on ON position
The panel bolts are not
correctly inserted
The quick-fastening
levers are not tightened
The grass is not uniform or
thick, or the cutting height
was not correctly adjusted
The grass cuttings are
damp and sticking
to the mower
The grass is long, the
rear panel of the mower
and the blade are
dragging in very dense
grass, or the cutting
height is set too low
The cutting height
is too low
207
Solutions
To secure the battery
pack, make sure the
latches on the top
of the battery pack
snap into place
Charge the battery
pack according to the
instructions included
with your model
Press the on/off switch
Attach properly
Refer to chapter
"Start the product"
Adjust the height of
the handle and check
that the panel bolts
are correctly inserted
Tighten them
Check the height of
the wheels. All the
wheels must be set
to the same cutting
height so that the
mower can cut evenly
Wait for the lawn to
dry before mowing
Raise the cutting height
Raise the cutting height
Qualification
-
RU
-
-
RO
EN
-
-
-
FR
ES
PT
IT
EL
PL
KZ
UA