Publicidad
Idiomas disponibles
Idiomas disponibles
SETTINGS
Hint: Before starting initial setup you must connect antenna.
1
This section describes the initial settings when you
first turn on the power after purchase. The initial
setting items are shown below.
• LANGUAGE SELECTION
You can select the menu language displayed on
the screen among English, Spanish and French.
• AUTOSCAN (TV/DTV)
(Select "Air"
when using antenna)
The channels broadcasted
in TV and DTV are
automatically
scanned and memorized. Only the
receivable channels in the area where this TV is
used will be memorized.
AUTOSCAN (CATV)
(Select "Cable"
when using RF/Incoming cable)
The channels broadcasted
in CATV are automati-
cally scanned and memorized.
ii ii¸¸_ !i ¸¸iJ_ i lJ!i
3 Select your language using [A/v],
press
[ENTER].
When you first turn on the power, the following
screen is displayed.
The Antenna Confirmation
will be displayed in
the selected language after you press [ENTER].
4 Select destination of ANT. IN jack using [A/T],
press [ENTER].
5 Autoscan will start automatically.
1 After making all the necessary connections,
turn
on this TV.
2 Press [POWER].
Initial Setup menu will appear.
, This operation may take a few moments.
, If Initial Setup menu does not appear press
and hold [ENTER] for 3 seconds, initial setup
will appear then proceed to step 3. If you have
already turned on this TV before, refer to "LAN-
GUAGE SELECTION"
on page 17 to select a
language for the on-screen displays.
, When scanning is completed, the smallest
memorized channel will be displayed.
NOTES:
• The initial Autoscan
function can be executed for either "Air"
or "Cable" only once. When you change the connection
(Air/Cable),
set the "Autoscan" again. (Refer to page 13,)
° When the scanning is not completed.
Helpful Hint will be
displayed every time you turn on the power. If you have
previously
registered
channels
when this screen appears
you can select a channel with number buttons.
. Support hotline is provided on the front page of this
manual.
EN
Publicidad
