Thermador ME301YP Guia De Instalacion página 13

9 Electrical connection Electrical connection
Read these instructions to safely connect your appliance to the electrical supply.
Electrical connection
9.1 Electrical requirements
Make sure your electrical installation supports the
following requirements.
This appliance must be supplied with the proper voltage
and frequency and connected to an individual, properly
grounded branch circuit, protected by a circuit breaker or
fuse. To know the circuit breaker or fuse required by your
Model Circuit required
ME301YP 30 A
ME302YP 40 A
9.2 Location of the power outlet
Before you install the appliance, check the location of the
power outlet.
If the electrical supply is located in the cabinet opening,
¡
the electrical connection must be made prior to placing
the oven in the opening.
If the electrical supply is in an adjacent cabinet,
¡
electrical connection can be made after placing the
oven in the opening.
9.3 Routing the electrical conduit cable
Requirements
A hole in the cabinet has been prepared to route the
¡
electric conduit from the oven to the junction box.
Serviceability must be maintained. Do not shorten the
¡
electric conduit cable. Route the electric conduit cable
in a way to permit temporary removal of the oven.
The electrical conduit cable swivels where it is
▶
connected at the oven. Rotate the electric conduit cable
upward or downward and direct it through the prepared
hole in the cabinet.
model, see the rating plate to find the wattage
consumption and refer to the ratings table to get the circuit
breaker or fuse amperage.
All oven models on the front cover of this Installation
Guide are dual rated, designed to be connected to either
208 V or 240 V AC, 60 Hz, 4-wire, single-phase power
supply.
Watts @ 240 V Circuit required
6400 30 A
8500 40 A
Electrical connection en-us
Watts @ 208 V
4800
6500
13