Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting Guide
Problem
The processor will not operate.
Mill will not operate
Processor stops during
processing
Mini chopper/mill leaking from
blade assembly base.
Poor performance of tools/
attachments
Cause
No Power.
Bowl not fitted to power unit
correctly.
Bowl lid not locked on correctly.
Mill not locked on correctly.
Mill not assembled correctly.
Processor overloaded/maximum
capacities exceeded.
Lid unlocked.
Seal missing
Seal incorrectly fitted
Seal damaged.
Refer to hints in relevant 'using the attachment' section. Check attachments are
assembled correctly.
15
Solution
Check processor is plugged in.
Check that the feed tube is positioned to the
front and the bowl handle is aligned to the
right hand side.
Check that the lid interlock is located
correctly into the handle area.
The processor will not work if the bowl
and lid are fitted incorrectly.
Mill will not operate if fitted incorrectly to the
interlock.
Check blade assembly is fully tightened into
the jar
Check maximum capacities stated in the
recommended usage chart.
Check lid is locked correctly.
Check seal is fitted correctly and not
damaged. To obtain a replacement seal see
'Service and customer care'.
Publicidad
