cecotec CONGA 12090 TWICE ROLLER HOME&FILL Manual De Instrucciones página 62

ENGLISH
Do not use the self-emptying base without the water tank, dirt-disposal bag, etc. installed.
-
Be sure to place the water tank inside the self-emptying base. The self-emptying base has
a factory-fitted dirt-disposal bag.
Self-emptying bases undergo a water test before leaving the factory. It is normal for a
-
small amount of water to remain in the water tank.
- Do not expose the self-emptying base to direct sunlight or block the infrared sensors with
any objects, otherwise the robot vacuum cleaner may not be able to automatically return
to the base.
Filling up the water tank
1. Open the top cover of the self-emptying base and remove the water tank.
2. Open the top cover of the water tank and fill it up. Do not fill up the water tank above the
MAX mark and below the MIN mark. Fig. 8
3. After adding water, close the top cover and secure the water tank release tab.
4. Refit the water tank in the self-emptying base and press down the top cover to secure it
in place.
Note:
Do not add hot water to the water tank to avoid deformation of the tank.
-
If you notice water stains on the outside of the water tank, wipe them with a soft, dry cloth
-
before use.
3. OPERATION
Charging and switching the robot vacuum cleaner on
1. Place the robot vacuum cleaner on the floor, with the rear facing the self-emptying base,
then centre it.
2. Push the robot vacuum cleaner all the way to the back of the base. Make sure the guide
wheel of the robot vacuum cleaner's dirt tank fits into the alignment guide of the self-
emptying base, and that the robot vacuum cleaner is recharging. The robot vacuum
cleaner will automatically start recharging once its charging terminals touch the charging
terminals of the self-emptying base. After about 5 seconds, the light of the robot vacuum
cleaner will turn on accompanied by an acoustic signal, indicating proper switch-on.
If the robot vacuum cleaner leaves the self-emptying base, hold down
-
light turns steady white and manually place the robot vacuum cleaner in the self-emptying
base for charge following the steps above.
Note:
If the battery is low, it may not be possible to switch the robot vacuum cleaner on. Manually
-
take the robot vacuum cleaner to the self-emptying base. During recharge, the
and the indicator light ring will light up orange.
62
until the indicator
button