Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Mop roller
1. Remove the mixed tank from the robot vacuum cleaner and turn it upside down.
2. Pull the handle on the right side of the roller mop to remove the mop roller as shown in
Figure 20.
3. Use the self-cleaning brush to remove tangled hair. To remove surface stains, wash with
clean water. Make sure it is completely dry before refitting it.
4. Refit the mop roller.
Note:
It is recommended to replace the mop roller every 3-6 months for best cleaning results.
Robot vacuum cleaner sensors
Clean the sensors of the robot vacuum cleaner with a soft, dry cloth, including:
1. The four fall-detection sensors on the underside of the robot vacuum cleaner. Fig. 21
2. The ToF sensors, the laser sensor, and the front infrared sensors shown in Figure 22.
3. The charging and docking terminals on the rear of the robot vacuum cleaner. Fig. 23
Replacing the dirt-disposal bag
If the dirt-disposal bag is full, the
a new one following the below instructions:
1. Open the top cover of the self-emptying base, pull up the handle of the dirt-disposal bag,
and remove the bag. Fig. 24
Note: Remove the mixed tank from the robot vacuum cleaner before turning it upside down.
2. Discard the used dirt-disposal bag. Fig. 25
Note: it is recommended to change the dirt-disposal bag every 6-8 weeks.
3. Insert a new dirt-disposal bag into the self-emptying base as shown in Figure 26 and make
sure the handle is locked.
If the
indicator light changes to white, close the top cover of the self-emptying base.
-
If the
indicator light does not change to white, please re-insert the dirt-disposal bag
-
all the way.
Cleaning the water tank of the self-emptying base
1. Open the top cover of the self-emptying base and remove the water tank. Fig. 27
2. Open the top cover of the water tank and empty the waste and clean-water tank.
3. Clean the inside of both tanks and use the self-cleaning brush to remove stubborn stains.
Fig. 28
Note:
It is recommended to clean the water tank weekly to avoid bacterial growth or bad odours.
4. Add clean water to the clean-water tank. Do not fill up the water tank above the MAX mark
and below the MIN mark. Fig. 8
68
indicator light will flash slowly. Replace the old bag with
Publicidad
