Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
After recharge,
-
Note:
If the robot vacuum cleaner cannot find the self-emptying base, it will automatically return
to the starting position. Please manually place the robot vacuum cleaner back in the self-
emptying base for recharge.
Malfunction
If a malfunction occurs during operation, the robot vacuum cleaner ring indicator light or
the corresponding self-emptying base indicator light will rapidly flash orange and the robot
vacuum cleaner will beep. Please refer to the Troubleshooting section.
Note:
-
If the robot vacuum cleaner isn't in the self-emptying base and no action is performed for
10 minutes during a malfunction, the robot vacuum cleaner will automatically enter Sleep
mode.
-
If a malfunction occurs, the robot vacuum cleaner will return to the self-emptying base for
recharge, and cleaning will end.
Resetting to factory settings
If the robot vacuum cleaner does not respond to any button presses, first press the Reset
button to force it to switch off, then press the Power button to restart it. If it still malfunctions,
hold down the
cleaner will be restored to factory default.
4. CLEANING AND MAINTENANCE
Warning
Be sure to remove the mixed tank before turning the robot vacuum cleaner upside down.
Dirt tank
1. Press the tank release tab downwards and remove the tank as shown in Figure 11.
2. Open the dirt-tank cover and pull up the filter module.
3. Dirt can be removed with a small brush or by shaking carefully against a hard surface for
dust to fall off. You can also use warm water without detergents to get a better result. Fig.
12
4. If you wish to wash the filter, make sure it is completely dry before refitting it to prevent
moisture from getting into the motor and damaging the robot vacuum cleaner. Fig. 13
66
will stay on, and ring indicator light will light up steady white.
and the
buttons simultaneously for 15 seconds: the robot vacuum
Publicidad
