cecotec POWER TITANIUM 500 EASYGO Manual De Instrucciones página 18

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Lid (x2)
2. Blending container (x2)
3. Blades
Main body
4.
5. Cooling tube (x2)
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
product.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent product damage when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box contents
- PowerTitanium 500 EasyGo blender
- Blades
- 2 600-ml blending containers
- 2 lids with handle.
- 2 cooling tubes.
- Instruction manual
- Wash and dry the blender and its accessories carefully before use. Then, place the blender
on an even, firm, and dry surface.
34 POWER TITANIUM 500 EASYGO
3. OPERATION
1. Fill the cooling tubes with water up to the mark located on their surface. Put them in the
freezer for 12-24 hours.
2. Put the ingredients in the blending container. Make sure the ingredients do not exceed the
600-ml mark on the blending-container surface. Close the blending container with the
blade assembly and turn it upside down.
Warning
Make sure the cooling tubes are not inside the blending container before starting blending.
They can only be placed inside the blending container once ingredients have been processed.
3. Connect the device to a power supply and fit the blending container onto the main body.
Press the blending container and turn it slightly clockwise to lock it in place.
4. Press the button on the device to blend the food.
Note
Do not use the device for more than 1 minute without pauses and allow a 2 minute rest
between uses.
5. Turn the blending container counterclockwise to unlock it and remove it from the
appliance main body. Unscrew the blade assembly, screw the cooling tube onto the
blending container's lid, and close the blending container.
6. Unplug the device.
Note
The appliance may block when overfilled. If this happens: turn it off, unplug it, and remove pour
some of its contents out. Then, try again.
4. CLEANING AND MAINTENANCE
- Do not clean the main body, the power cord, or the plug with water.
- Clean the main body with a soft, wet cloth and some mild detergent.
- Fill half the blending container with hot water and some drops of detergent. Let the device
run until the blending container is clean.
- Clean the blending container, lid, tubes, and blades with hot water and some cleaning
agents. These parts can be washed in the dishwasher.
- Make sure all the product parts are completely dry before reassembling them and using
the device.
- Do not use abrasive cleaning agents.
ENGLISH
POWER TITANIUM 500 EASYGO 35