Costway ES10255 Manual Del Usuario página 8

■ Water Shortage Reminding Mode
－ Under the working process of ice making and washing mode,
when the water volume of the water storage room is too low or the
small water tank is not filled with water, the water shortage icon will
display, and there will be a "beep" sound for about 3S, then
automatically enter the water shortage reminding mode.
－ Under the water shortage reminding mode, shortly press the ice
making button to enter ice making mode.
■ Timer Setting
－ Press set button and the timer figures flashes to set real time.
When the first two figures are flashing, press the adjust button to set
the hours; when the last two figures are flashing, press the adjust
button to set the minutes.
－ The timer is set to 24-hour system. Each time the machine is
powered on, it is displayed 12:00.
－ If there is no timer figures displayed on the LED screen, the
timer set cannot be conducted.
■ Appointment Function
－ In standby mode, shortly press the set button 3 times
continuously to set the countdown of ice making appointment.
－ Countdown of ice making appointment can be set to 12 hours at
longest and 1 minute at shortest.
－ When the timer figures no longer flash and the appointment
icon is displayed, it means that the appointment function is enabled.
The machine will start ice making when countdown is over.
－ When the appointment function is enabled, shortly press the ice
making button to enter ice making mode, long press set button to
cancel appointment function.
－ Shortly press the ice making button to cancel the current
appointment (the appointment icon dims) and enter ice making
mode.
－ When the timer figures no longer flash and the appointment icon
is displayed, it means that the appointment function is enabled. The
machine will start ice making when countdown is over.
◇ Each time a button is pressed, a "beep" sound will be heard.
14
Water Filling and Drainage
■ Water filling (manual)
－ When the water volume in the water storage area is too low or
there is a water shortage reminder, it needs to fill water.
－ Manually fill drinking water into the water storage area.
－ The amount of water filled e each time must not exceed the
maximum water level mark.
◇ Warning: fill with potable water only.
■ Water filling (automatic, only YT-E-010BA1 supports this function)
－ Place the inlet pipe into a water bucket (jug) and make it under
the water.
－ When the amount of water in storage area is lower than the
lowest position of the float ball switch, water will automatically fill in
the ice maker.
◇ Warning: Fill with drinking water only.
◇ Warning: The machine can only be connected to an external
water source without pressure.
■ Water Drainage
－ Drainage is required when the water in the storage area is
contaminated or when the inner walls of the storage area need to be
cleaned.
－ Pull out the plug before drainage.
－ Properly move the ice maker, place a water storage container
directly under the ice machine drainage pipe.
－ Pull out the drain plug and the water will flow out automatically.
－ After draining is finished, drain plug should be plugged in
immediately.
◇ When filling or draining water, make sure that no water is filled or
splashed to the live parts of the equipment to avoid danger.
◇ When using the machine again after drainage, please check
whether there is water leakage at the drain outlet, ensure there is no
leakage before continuing to use.
15