Costway NP10994 Manual Del Usuario página 8

The quick release mechanism has to be positioned on towable
(in case of use by children below the age of 14 on towing boat).
NOTE: The user (rider) should not trigger the quick release for
interrupting a normal safe ride without urgent reasons. National
rules shall be considered additionally.
Signal devices
The watercraft shall be equipped with a towing streamer/flag in
order to advise other watercrafts that towing is occurring.
Maintaining and monitoring proper inflation
It is important to monitor the amount of air in your product as
heat will cause the bladder to expand, possibly damaging seams
or l-beams. If you leave a full tube sitting in the sun for any
length of time it will expand. Either store it in the shade or let
some air out. Don't leave your product on the beach, dock, or
boat full of air! If the product is stored out of the sun in a cool
place, you may need to add some air. Check and adjust the
inflation level each time you use your product for maximum
performance and enjoyment.
MAINTENANCE, STORAGE AND REPAIR
Maintenance and storage
When taking the product out of the water, pull it out using the
front towing strap so the water is able to drain out of the drains
in the bottom back. Allow the towable to dry completely to
prevent mildew. If using in salt water, rinse the product with
fresh water and allow to dry completely before storing. For
cleaning, use only water or soapy water. Release all of the air
from the chambers and fold the towable.
14
It is best to store the product inside a warm, dry area. Do not
unfold the product at temperatures below 15°C (59°F) and do
not expose it to frosty temperatures, as it can damage the
material and cause cracks in the PVC bladder. Do not expose
the product to direct sunlight, UV radiation causes colors to fade
and accelerates aging.
Repair
Smaller holes or cracks in the bladder can be repaired with the
enclosed repair kit as follows:
1. Please clean and dry the deflated product.
2. Align small defect areas (pinholes and cracks) up to about
2inches(5cm) length one another carefully and apply a thin coat
with repair glue, let it dry for about 10 minutes with warmth
(sun). Then repeat this process every 10 minutes up to 5 times.
An adhesive applied does not need to be removed. Adhesive
must be dry before applying the next layer.
3. In case of a larger defect, apply a 1/2 cm wide thin layer of
glue on the damaged edge and put on the cutted foil patch right
away and press firmly. Repaint edge of patch after about 10
minutes and repeat according point 2. Too much glue makes the
material soft and prolongs the repair time.
4. Item must necessarily rest 12 hours before use.
5. Don't let the article vulcanize, do not use a different adhesive.
6. The repair must be performed only by adults. Keep adhesive
and fabric patches away from children! Avoid skin contact!
Protect your eyes! Do not swallow! Use only in well ventilated
room! Not a toy!
Before reuse, the product should be carefully checked.
15