Publicidad
OPERATION
ATTACHMENTS
This unit can use many different attachments. See the attachment
page in this book. This unit can pull attachments
like a lawn
sweeper, a lawn aerator, a hopper spreader, or a small trailer. This
unit can not use attachments that engage the ground like a plow, a
disk harrow, or a cultivator.
For all pull-behind
attachments
or trailers, the maximum gross
weight is 200 pounds. Gross weight is the weight of the attachment
or trailer and any load that might be on or in it.
Do not operate on a slope that is greater than 10 degrees when
using a pull-behind
attachment or trailer. We have included a slope
guide in this book to help you determine the slope on which you will
be operating your unit. Never allow someone to stand or ride on or
in an attachment or trailer.
ELECTRICAL
SAFETY
SYSTEM
The electrical system has two primary components, an Operator
Presence System and a Select Reverse ,Msystem.
Operator
Presence
System
(Seat)
The seat has an Operator Presence System to shut off the engine
when the operator leaves the seat. This system is not intended for
regular use in stopping the engine or the blade(s). Before leaving the
seat, move the blade rotation control to the DISENGAGE position,
shift to neutral, set the parking brake and stop the engine.
Select Reverse
TM
System
The Select Reverse 'M system will allow the mower blade(s) to
continue to rotate when traveling in reverse. See "How To Operate
The Ignition Key Switch" and "How To Start The Engine" for further
details.
HOW TO OPERATE
THE IGNITION
KEY SWITCH
Use the ignition key switch to start and stop the engine. When you
start the engine and release the ignition key, the ignition key switch
wilt automatically default to the recommended RUN-MOW
position
for normal mowing.
START
- Use this position to start the engine.
RUN-MOW
- When you start the engine and release the ignition
key, the ignition
key switch
will automatically
default
to the
recommended
RUN-MOW
position
for normal
mowing. In the
RUN-MOW
position,
the system
will stop the engine and the
blade(s) when the speed control pedal/shift
lever is put in the
reverse position.
SELECT
REVERSE
'M -
The
optional
Select
Reverse '_
position wilt allow the mower blade(s) to continue to rotate when
traveling
in reverse.
Always
go back to the
recommended
RUN-MOW position for normal mowing when operation in Select
Reverse '" is not absolutely
necessary. NEVER use the Select
Reverse'M option if children are on or near the property.
_
WARNING:
Operators are strongly
discouraged
from using this option unless the operator
de-
cides such operation is absolutely necessary and
that safe precautions
are taken. Never use the Select Re-
verse ,Moption if children are on or near the property. Always
look down and behind before and while backing. After using
the Select Reverse M position, move the ignition key back to
the RUN-MOW position.
STOP - Use this position to stop the engine.
F-050610L
11
Publicidad
