Publicidad
OPERATION
HOW TO OPERATEWITH THE MOWER HOUSING
WARNING: The mulch cover is a safety device. Do not
remove the mulch cover. The side discharge attach-
,_
ment
forces the discharged
material
toward
the
ground. Always keep the side discharge attachment
in the down position. If the side discharge attachment
is damaged, replace the with an original equipment
part from a Sears Service Center.
IMPORTANT:
When you operate
with the mower housing,
always operate with the throttle control in the FAST position.
1.
Push the clutch/brake pedal completely forward.
2.
Start the engine.
3.
Put the speed control lever in the NEUTRAL position.
4.
Slowly release the clutch/brake pedal.
5.
Move the lift lever to a height of cut position. In high or thick
grass, cut the grass in the highest position first and then lower
the mower housing to a lower position.
6.
7.
8.
9.
10.
CAUTION:
Do not operate with the mower housing in the
LEVEL ADJUSTMENT
position.
If you operate
in the
LEVEL ADJUSTMENT
position, the mower housing and
blades can be damaged.
Move the throttle control to the SLOW position.
Move the attachment
clutch to the ENGAGE position.
Move the speed control lever forward.
NOTE: When you mow in heavy grass or mow with a
bagger, operate at a slow forward speed.
Move the throttle control to the FAST position. If you need to go
faster or slower, move the speed control lever forward or back-
ward.
Make sure the level of cut is still correct. After you mow a short
distance, look at the area that was cut. If the mower housing
does not cut level, see the instructions on "How To Level The
Mower Housing" in the Service And Adjustment section.
,_
WARNING:
For better control of the unit, always
select a safe speed.
HOW TO OPERATE THE UNIT ON HILLS
,_
WARNING: Do not ride up or down slopes that are too
steep to back straight up. Never ride the unit across
a slope. See the "Slope
Guide" in the back of this
book for information on how to check slopes.
1.
Before you ride up or down a hill, move the speed control lever
to a slow speed.
2.
Do not stop or change speed settings on a hill. If you must stop,
quickly push the clutch/brake pedal forward and set the parking
brake.
3.
To start again, make sure the speed controllever
is in a slow
speed. Move the throttle control to the SLOW position. Slowly
release the pedal.
4.
If you must stop or start on a hill, always have enough space
for the unit to roll when you release the brake and engage the
clutch.
5.
Be very careful when you change directions on a hill. When on
a slope or in a turn on a hill, move the throttle control to the
SLOW position to help prevent an accident.
F-050610L
19
Publicidad
