Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
•
Both electric and mechanical installation must be ca-
rried out by specialised personnel.
•
The cooktop is designed to be built into a work top
with a minimum thickness of 3 cm for both types of
installation.
•
The minimum distance between the hob and the wall
must be at least 5 cm in front, at least 4 cm on the
sides and at least 50 cm from overhead wall units.
NB = The recommended distances are given as examples:
when planning the spaces, the indications of the kitchen
manufacturer must be observed.
PREPARATION FOR INSTALLATION:
Before starting the installation:
•
After unpacking the product, check that it has not
been damaged during transport and in the event of
problem, please contact the reseller or the customer
support service before installing it.
•
Check that the product is the right size for the installa-
tion area.
•
Check for accessories (e.g. bags containing screws,
warranty certificates, etc.) inside the packaging (pla-
ced there for transport reasons). Remove and keep
them safe, if present.
•
Also check that there is a power socket near the insta-
llation area.
PREPARING THE CABINET FOR INSTALLATION:
•
The product cannot be installed above cooling
appliances, dishwashers, heaters, ovens, washing ma-
chines and dryers.
•
Create the cut-outs in the cabinet before inserting the
hob and carefully remove any shavings or sawdust.
I
CAUTION
Failure to install screws and fasteners in accordance with
these instructions may result in electrical hazards.
I
IMPORTANT
Use a single-component adhesive sealant (S), which withs-
tands temperatures up to 250°; before installation, thorou-
ghly clean the surfaces to stick and eliminate any substan-
ce that may compromise adhesion, (e.g. release agents,
preservatives, fats, oil, dust, traces of old adhesives, etc.);
the adhesive should be uniformly spread all around the
outside of the frame; after sticking, leave the adhesive to
dry for about 24 hours.
s
1/4"
s
3-Wire Cable from Home Power Supply to 3-Wire Cable
from Cooktop
IMPORTANT
: Use the 3-wire cable from home power su-
pply in the U.S. where local codes do not allow grounding
through homes and recreational vehicles, new construc-
tion, and in Canada.
A
B
C
D
A. Cable from home power supply
B. Black wires (Phase)
C. Green or yellow-green ground wires (ground)
D. Conduit with 3-Wire from cooktop
E. Junction box
F. UL listed wire connector (not supplied)
G. Red wires (Phase)
H. UL listed or CSA approved conduit connector (not
supplied).
1.
Connect the 2 black wires together using the UL listed
wire connectors.
2.
Connect the 2 red wires together using the UL listed
wire connectors.
3.
Connect the green (or yellow-green) ground from the
cooktop cable to the green (or yellow-green) ground
wire (in the junction box) using the UL listed wire
connectors.
4.
Install junction box cover.3-Wire Cable from Home
Power Supply to 3-Wire Cable from Cooktop - U.S.
Only.
8
E
F
G
H
Publicidad
