Publicidad
Idiomas disponibles
Idiomas disponibles
The operation of any tractor can result in foreign objects thrown into the
eyes, which can result in severe eye damage. Always wear safety glasses
or eye shields while operating your tractor or performing any adjustments
or repairs. We recommendstandard safety glasses or a wide vision safety
mask worn over spectacles.
HOW TO USE YOUR TRACTOR
TO SET PARKING
BRAKE
Your tractor is equipped with an operator
presence sensing
switch.
When engine
is running, any attempt by the operator
to leave the seat without first setting the
parking brake will shut off the engine.
1. Depress clutch/brake
pedal (B) all the
way down and hold.
2. Pull parking brake lever (C) up and
hold, release pressure from clutch/
brake pedal (B), then release park-
ing brake lever.
Pedal should remain
in brake position.
Make sure parking
brake will hold tractor secure.
• Turn ignition key (F) to "STOP" position
and remove key. Always remove key
when leaving tractor to prevent unau-
thorized use.
Never use choke (N) to stop engine.
IMPORTANT:
Leaving the ignition switch in
any position other than "STOP" will cause
the battery
to discharge
and go dead.
NOTE:
Under certain conditions
when
tractor is standing idle with the engine
running, hot engine exhaust gases may
cause "browning"
of grass. To eliminate
this possibility, always stop engine when
stopping tractor on grass areas.
_,CAUTION:
Always stop tractor com-
pletely, as described
above, before leaving
the operator's
position.
STOPPING
MOWER
BLADES
-
• To stop mower
blades,
push attachment
clutch
switch
in to disengaged
position
(o).
(I) Attachment
Clutch Switch
Pull Out To "Engage"
(O) Push-In to
"Disengaged"
GROUND
DRIVE
-
• To stop ground
drive,
depress
brake
pedal all the way down.
ENGINE
-
• Move throttle
control
(D) between
half
and full speed
(fast) position.
NOTE:
Failure
to move throttle
control
be-
tween
half and full speed
(fast) position,
be-
fore stopping,
may cause engine to "backfire".
TO USE THROTTLE
CONTROL
(D)
Always
operate
engine
at full speed
(fast).
Operating
engine
at less than full speed
(fast) reduces engine's
operating
efficiency.
Full speed
(fast) offers
the best mower
performance.
TO USE CHOKE CONTROL
(N)
Use choke control whenever
you are start-
ing a cold engine. Do not use to start a
warm engine.
• To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE
FORWARD
AND
BACKWARD
The direction
and speed
of movement
is
controlled
by the forward
and reverse
drive
pedals.
14
Publicidad
