RIDGID R4021SN Manual Del Operador página 23

ADJUSTMENTS
SPLASH HOOD BRACKET ADJUSTMENT
See Figure 26.
To check the squareness of the splash hood bracket to the
rip guide, see Aligning the Rip Guide With the Cutting
Wheel earlier in this manual.
When those adjustments have been performed, check the
alignment of the splash hood bracket to the cutting wheel.
 Unplug the saw and remove the bevel table.
 Raise the splash hood.
 Loosen the three bracket screws.
 With the rip guide touching the cutting wheel, adjust the
splash hood bracket until it is aligned with the rip guide.
 Using a Phillips screwdriver, securely tighten the screws.
ADJUSTING LOCKING LEVER ASSEMBLY
See Figure 27.
Over time, the rip guide may become loose. If the rip guide
does not lock securely to the saw table, adjustments may
be required.
 Unplug the saw and remove the rip guide.
 Using a hex key, loosen the cam screw.
 Turn the cam to tighten as desired.
NOTE: An arrow is visible on the roller. The wider end of
the arrow is the tighter end of the adjustment. The smaller
end of the arrow is the looser end of the adjustment.
 When the desired adjustment is made, tighten the cam
screw securely.
CAM
SCREW
23 — English
BRACKET
SCREWS
Fig. 26
CAM
Fig. 27