Publicidad
Idiomas disponibles
Idiomas disponibles
•
Remove the plug from the socket when the rice cooker is not in use.
•
The rice cooker requires sufficient space at walls, and underneath furnishings and shelves, to
allow the steam to escape.
•
Do not damage the power supply cable. Under no circumstances should the cable be be
kinked, twisted or modified. Never place the cable under or between heavy objects.
A damaged power cable can cause electric shock or fire. fire. If your power cable
is damaged, you can order a new one from our shop, or from the Customer Service
at support@reishunger.de to order a new one.
•
Only use the rice cooker with the accessories provided.
•
Never place the rice cooker on or near hot surfaces (e.g. hobs).
•
After using the rice cooker, do not touch any hot surfaces on the appliance. Be careful when
opening the lid of the rice cooker, as hot steam may be released. Take care to only touch the
internal pot of the rice cooker on the handles and nowhere else when stirring the rice. Touching
metal surfaces – e.g. the inner part of the lide, the internal pot in the rice cooker or the heat
plate – can result in burns.
•
Place the rice cooker on an easily accessible, level, waterproof, heat-resistant and sufficiently
stable work surface. Do not place the rice cooker at the edge of the work surface. Do not place
the rice cooker on a surface that cannot bear the weight of the rice cooker. Otherwise the
surface may be damaged and the rice cooker may fall, which could result in injury. The table or
extending table must have a load-bearing capacity of at least 18 kg.
DISPLAY
STATUS
Termination of
E1
all processes
Termination of
E2
all processes
Termination of
E3
all processes
Termination of
E4
all processes
REASON
Open circuit on
lower sensor
(below –15°C)
Open circuit on
upper sensor
(below –15°C)
Short circuit on
lower sensor
(above 190°C)
Short circuit on
upper sensor
(above 190°C)
SOLUTION
Set the temperature sensor correctly
(bring the unit to room temperature)
and switch on the power supply again.
Set the temperature sensor correctly
(bring the unit to room temperature)
and switch on the power supply again.
Set the temperature sensor correctly
(bring the unit to room temperature)
and switch on the power supply again.
Set the temperature sensor correctly
(bring the unit to room temperature)
and switch on the power supply again.
41
Publicidad
