Clatronic BS 1302 Instrucciones De Servicio página 32

• Never use without the filter. Check that the filter is inserted correctly!
• Hair, clothing and body parts away from the vacuum nozzle during
use!
• Keep the vacuum cleaner away from sources of heat like radiators,
ovens, etc.!
Overview of the Components
1 Air slide
2 Handle
3 Suction hose
4 Cover lock (dust container)
5 On / off switch
6 Carrying handle
7 Dust collector release button
8 Cable-winding button
9 Suction power control
10 Ventilation grill lock (outlet filter)
11 Positioning aid
12 Dust container
13 Dust collector base plate
14 Hose connection
15 Connection head of the vacuum hose
16 Carpet / hard floor selector
17 Floor nozzle (with hook (not shown))
18 Telescopic suction tube
19 Parquet brush
20 Combined brush / crevice nozzle
Start-up
• Insert the connecting head of the suction hose into the
hose connection of the appliance. It must lock mechan-
ically.
• To disconnect the hose again, press the button on the
connecting head.
• Insert the vacuum tube into the handle if required.
• You can use the sliding switch on the telescopic suction
tube to adjust the length individually. (Page 4, Fig. A)
• Then assemble the floor nozzle and / or the accessories.
Nozzle Attachment
Floor nozzle (17)
You can clean smooth surfaces and carpets with the floor
nozzle.
Set the selector (16) according to condition of the floor:
For durable hard floors like laminate, tiles, PVC,
etc.
For carpet floors, rugs, etc. with high or low pile
32
BS1302_IM
Parquet brush (19)
For gentle cleaning of sensitive hard floors like parquet,
laminate, tiles, etc.
Combined brush / crevice nozzle (20)
For vacuuming upholstery, curtains and in corners and
crevices etc.
NOTE: "2-in-1" nozzle:
When this is folded together it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull the
brush section in the direction of the arrow until it locks in
place.
To detach the nozzle attachments from the suction pipe, pull
them off by turning them slightly.
Using the Appliance
1. Unwind the length of cable you require.
CAUTION:
• Pull out the cable up to the maximum length indicat-
ed with the yellow mark.
• Never pull the cable out up to the red mark as the
cable winding can be damaged.
NOTE:
If the red mark is visible, pull in the cable with the help
of the cable winding button back to the yellow mark.
2. Insert the mains plug into a correctly installed power
socket.
3. Turn the device on by the on / off switch by pressing down
the button.
4. Set the "carpet / hard floor" selector, depending on the
floor covering.
5. Set the suction power with the suction power controller.
6. Vacuum at a steady speed. There is no need to exert
pressure.
NOTE:
Pay attention to the range that can be covered with the
cable length!
Air Slide (1)
Open the air slide on the hose handle in order to regulate the
airflow or to clear any particles sticking to the nozzle.
08.03.16