EdilKamin DEMY Instalación Uso Y Mantenimiento página 30

• ELECTRONIC EQUIPMENT
LEONARDO is a combustion safety and control system which allows optimal perfor-
mance in all conditions thanks to two sensors measuring the pressure level in the combu-
stion chamber and smoke temperature.
The detection of and subsequent optimisation of these two parameters is continuous in
order to correct operation anomalies in real time.
The LEONARDO system offers constant combustion, automatically regulating the draft
based on the characteristics of the chimney ue (bends, length, shape, diameter, etc.) and
environmental conditions (wind, humidity, atmospheric pressure, installations at high al-
titude, etc.). The standards for installation must be respected. The LEONARDO system
is also able to recognise the type of pellets and automatically adjust the ow moment by
moment to ensure the required level of combustion.
• ELECTRONIC CIRCUIT BOARD
serial port/
AUX
hearth safety
microswitch
remote-control device
ventilation
Screw-1
ambient
Dumper wood-pellet
SERIAL PORT
The Dealer can install an optional on the AUX outlet for controlling the process of
switching on and off (e.g. telephone remote, local thermostat), located at the rear of the
stove. This can be connected via special optional trestle (code 640560).
BACKUP BATTERY
A backup battery is found on the control board (3-Volt CR 2032 battery). Its malfunction
is indicated with the following messages (not considered a defect but due to normal
wear-and-tear): "Battery check". For more detailed information, please contact the DEA-
LER who performed the rst 1st ignition.
GENERAL INFORMATION
seismic sensor
dumper safety
microswitch
ambient-
Vacuum gauge
air sensor
Screw
Reading
points sensor
Smoke expul-
sion motor
Screw-2
Emergency
button
burner
blower
FUSE *
Two fuses are inserted in the socket with
switch, located on the back of the stove,
one of which operational * and the other
is held in reserve **.
- 30
-
*
* patented
* **