DrBrowns Insta-Feed AC184-INTL Instrucciones De Uso página 4

WARMING BOTTLES AND FOOD JARS
CAUTION: Always unplug the warmer before filling.
Do not use Sterilizing Lid for warming.
1
Remove the Measuring Cup from the rear of the warmer.
2
Add water to the Measuring Cup, following the Warming
Guide on page 5 to determine the amount of water to
add based on your bottle type.
Note: These amounts are a guide only. There are many variables
that can impact the final temperature of the bottle or food jar you are warming, such as starting
temperature, size, and shape. Always test the temperature before feeding your baby.
3
Pour the water from the Measuring Cup directly into the Warming Chamber. Do not overfill, as
overfilling may cause the bottle/food jar to be overheated or may cause damage to the unit.
4
Replace the Measuring Cup and plug in the power cord.
Note: The first time the unit is plugged in, the warming cycle may begin automatically. If the
Indicator Light is on upon plugging unit in, wait for the warming cycle to end (Indicator Light
will turn off) and allow the unit to cool down for 10 minutes before using.
5
Place the bottle or food jar inside the Warming Chamber as outlined below.
Wide Neck Bottle: Place bottle directly into Warming Chamber.
Narrow Bottle: Place Adapter Ring on top of Warming Chamber,
then place bottle in Warming Chamber. The Adapter Ring will
keep your bottle centered over the heating plate for even warming.
Note: To prevent leakage when warming Dr. Brown's® bottles,
remove the internal parts, collar, and nipple/teat, and replace with
the included Storage Cap.
Food Jar: Place food jar into the Lift-Out Basket, then place Lift-Out Basket
in Warming Chamber.
Note: Always remove the lid of the food jar prior to warming. After warming cycle is
complete, be sure to stir food thoroughly until it is an even temperature throughout.
6
Press the Power Button. The Indicator Light will turn on, indicating the warming cycle
has begun.
CAUTION: Always add water and then press Power Button. If the Power
Button is pressed first, steam may form when water is added.
WARNING: DO NOT reach over the appliance while in use, as steam will
cause burns and serious injuries. Do not touch hot surfaces during or
immediately after use.
Note: If the Power Button is pressed without water added, the unit will shut off automatically
after a short period. If this happens, wait at least 10 minutes to allow warmer to cool before
adding water and starting warming cycle.
7
When the Indicator Light turns off, the warming cycle is done. Remove the bottle/food jar
promptly to avoid overheating. Gently stir or swirl content to ensure it warms evenly.
DO NOT shake.
Note: Always test the temperature before feeding your baby. Adjust the amount of water added
to the warming chamber as needed; if the bottle/food jar is too cold, add slightly more water
next time. If the bottle/food jar is too warm, use slightly less water next time.
8
Wait at least 10 minutes to allow warmer to cool before using again.
3
USE DISTILLED
OR NON-MINERAL
BOTTLED WATER
Tap water contains minerals
that shortens the life
of this appliance.