Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: Be sure to observe the 10-minute cooling time as warmer
parts and sterilized parts will be hot. Always remove the Sterilizing Lid
carefully by the handle. Take care when removing the Sterilizing Lid as
there may be some residual steam—keep hands and face away. Allow the
steam to clear before reaching into the unit. Always retrieve the sterilized
parts by removing the Lift-Out Basket.
1
4
7
TROUBLESHOOTING TIPS
•
If the warmer is not operating, check that the power cable is connected to the power outlet and
water has been added to warming chamber.
•
If Indicator Light does not come on/warming cycle does not start, warmer may be cooling
down. Wait 10 minutes and try again.
•
If Indicator Light comes on upon plugging in but before Power Button is pressed, it is possible
the Power Button was pressed while the warmer was unplugged. Wait for the warming cycle to
end (Indicator Light will turn off) and allow the unit to cool down for 10 minutes before using.
•
If bottle/food is too warm/too cold after warming cycle, note the Warming Guide only shows
approximate amount of water needed. Warming times are impacted by many variables, so
adjust the amount of water added as needed. If the bottle/food jar is too cold, add slightly more
water next time. If the bottle/food jar is too warm, use slightly less water next time.
2
5
8
10
3
6
6
Publicidad
