Publicidad
EN
4)This product should be set up on a flat surface 2m/6.5' away from all
other things, structures or obstacles (walls, fences, trees, washing lines or
electric cables etc.) that could cause injury during use.
5)This product must not be set up over hard surfaces such as concrete,
asphalt or other hard surfaces. We recommend installation over grass or
other such soft surfaces.
6)This product must be embedded firmly into the ground. Please follow
the instructions carefully for doing so. Only use this product when the
concrete is dry.
7)Anchors should be placed level with or below ground level in order to
reduce tripping hazards.
8)The anchorage must be checked regularly, in addition to the hooks and
fixtures.
9)Dispose of packaging thoughtfully.
10)Do not allow children to play with packaging.
11)During the assembly, keep children away the toy to avoid child swallow
the small accessories.
MAINTENANCE
1)All metal parts are galvanized steel and powder coated for rust protection.
However, in certain areas close to the sea, we advise that additional rust
prevention treatment may be necessary.
2)The surfaces of all the parts should be checked at least once a month,
especially for the fixtures such as hooks on the overhead beam. If the fixtures
and hooks show wear over 10% of their original thickness, then they should
be replaced with the same fixtures as those originally provided.
3)To check all nuts and bolts for tightness and tighten when required.
16
4)To check all coverings for bolts and sharp edges and replace
when required.
5)Toys may collapse or be dangerous if they don't check regularly.
6)The ground on which the product is placed should be controlled
regularly. All elements such as stones or other objects that could
cause injury in the case of a fall should be removed. It is advised to
remove the apparatus during the
winter period or when not in use, to avoid any deterioration due to
bad weather conditions.
7)All used apparatuses and/or parts must be replaced by a part
delivered by our after sales service.
8)Any modifications made by consumer to the original activity toy
shall be carried out according to the instructions of the
manufacturer.
9)Sand rusted areas and tubular members, and repaint using a
non-lead based paint when required.
PRACTICAL ADVICE
Safety checks should be carried out regularly on this product. These
checks should include, if necessary, removing any sharp edges,
replacing missing screw covers, and tightening the nuts and bolts.
These checks should be done to avoid any danger or upturning through
normal wear and tear.
EN
17
Publicidad
