Dreame Vortech Z10 Manual De Usuario página 15

FAQ
EN
If the vacuum is not working properly, please refer to the table below.
Errors Possible Causes
The appliance is out of battery or
its battery level is low.
Overheat protection mode
Vacuum does not work.
triggered by a blockage.
The suction opening or air duct is
blocked.
The dust cup is full and/or filter
assembly is clogged.
Weak suction force.
An attachment is blocked.
The motor makes a strange Main suction opening or
noise. extension rod is blocked.
The battery indicator is
solid red when charging Battery pack is damaged.
the vacuum.
The battery indicator blinks The motor temperature is too
red after turning on the high. / The bush roller is blocked.
vacuum. / The air duct is blocked.
The vacuum is not properly
placed on the dust-removal hub.
The battery indicator
The battery is charged and
does not light up when
switches to Sleep Mode
charging.
automatically.
The problem persists after ruling
out the above two possibilities.
The battery temperature is too
Charging too slow.
low or too high.
LED lights of the multi-
surface brush and
LED lights are damaged.
motorized mini-brush do
not work.
The dust collection bag is
The dust collection status
uninstalled or inappropriately
indicator is solid orange.
installed.
The dust collection status The dust collection bag reaches
indicator is blinking capacity or the air duct is
orange. blocked.
9
Solutions
Fully charge the vacuum, then resume
use.
Clean the suction opening or air duct.
Wait until the vacuum cools down,
then reactivate it.
Clear any blockage from the suction
opening or air duct.
Empty the dust cup and/or clean the
filter assembly.
Clear any blockage in the attachment.
Clear any blockage in the main suction
opening or extension rod.
Please contact after-sales service for
maintenance.
Check these parts in turn.
Make sure that the charging contacts
of the vacuum is aligned with that of
the dust-removal hub.
The vacuum runs normally.
Please contact the after-sales
department for maintenance.
Wait until the battery temperature
returns normal, and then recharge.
Please contact the after-sales
department for maintenance.
Before dust collecting starts, confirm
that the dust collection bag has been
installed or installed in place.
Replace a new dust collection bag
or clean the air duct. Then press and
hold the dust collection button for 3s
to troubleshoot the problem.
Specifications
Vacuum Cleaner
Model VPV17A
Rated Power 481W
Multi-Surface Brush
Model
Rated Power 40W
Soft Roller Brush
Model
Rated Power 40W
Motorized Mini-Brush
Model
Rated Power 20W
Dust-Removal Hub
Model
Input 220-240V 50-60Hz
Rated Power
Rechargeable Lithium-Ion Battery Pack
Model V2308-7S1P-BCA
Rated Capacity 2700mAh
Energy
The lithium-ion pack contains substances that are hazardous to the environment. Before
disposing of the vacuum, please remove the battery pack, then discard or recycle it in
accordance with local laws and regulations of the country or region it is used in.
The appliance must be disconnected from the power supply when removing the battery.
Keep batteries out of the reach of children. Never put batteries in mouth. If swallowed,
contact your physician or local poison control.
Under abusive conditions, never contact the battery from which the liquid may be
ejected. If contact accidentally occurs, rinse with water. If liquid contacts eyes, seek
medical help immediately. Liquid ejected from the battery may cause irritation or burns.
approximately 3.5
Charging Time
hours
Rated Voltage 25.2V
VMB4
Rated Voltage 25.2V
VBR4
Rated Voltage 25.2V
VMMB
Rated Voltage 25.2V
VCB1
Output 30.8V 0.95A
1050W
Nominal Voltage 25.2V
Nominal Capacity 2900mAh
68.04Wh
EN
10