UFESA Nevada Manual De Instrucciones página 19

- Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the
drive pin that passes through the motor shaft.
- Tighten the blade cap by turning it anticlockwise.
ASSEMBLE OF THE SUPPORT TUBE
- Fix the decoration ring (1) on the front grill (2), and tight up by misting board lock screws.
- Position the front grill (2) and back grill (5) by grill ring (6), and tighten up by grill lock nut.
- Untighten the nuts (10), place the 2 support tubes into the base and tight again the nuts (10).
- The support tubes (23) have to be placed into the base (18) and tighten by screwing.
ASSEMBLE OF THE WATER TANK
- Make sure the product is unplugged from the mains before filling or refilling the water tank.
- Only put water in the water tank. Do not add any chemicals, oils or other additives.
- Only use cold or lukewarm water in the water tank. The water must not be warmer than 40°C.
- Unscrew the valve cover to open the tank turning it anticlockwise, fill the tank with cold
and clean water making sure not to overfill it. To close the tank, screw the valve cover back
on securely turning it clockwise (fig.2).
- Turn the tank over and place it back into its designated space at the back of the fan main
body (fig. 3).
- Insert the plug into the mains socket.
REMOTE CONTROL
- Supplied with batteries inside; Remote control is supplied with battery inside; remove
the transparent sheet from the battery cover before use remote control.
- When the battery is over, it must be replaced with the same type following the drawing
on the back of remote control.
OPERATION
- Press On/Off button (A) one time to activate the fan. The indicator light (6) will light on.
- You can now press MIST (E) button to select the misting function without fan operation
(mist only).
- Press On/Off button a second time to turn on the fan: the unit will operate at low speed
and normal mode. The related indicator light (2) will light on. You can now select other
functions (speed, mode, timer, mist).
- To turn off the machine, press again the on/off button.
REMOTE CONTROL FUNCTION
SPEED Button (B):
- To start the fan at low speed, press On/Off button (A) once (when unit is off): the unit will
operate at low speed and the related indicator light(2) will be on.
- Press speed button one time to select the medium speed: the related indicator light (2)
will be on.
- Press speed button another time to select the high speed: the related indicator light (2)
will be on.
19