HIKOKI EC36DA Instrucciones De Manejo página 9

REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe
the following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output
of 100 Wh are considered to be in the freight
classifi cation of Dangerous Goods and will require
special application procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
○ If the BSL36B18 is installed in the power tool, the power
output will exceed 100 Wh and the unit will be classifi ed
as Dangerous Goods for freight classifi cation.
Power Output
Wh
2 to 3 digit number
USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the
USB device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB
port with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
<USB charging>
○ Charging a USB device from an electrical outlet
(Fig. 7-a)
○ Charging a USB device and battery from an electrical
outlet (Fig. 7-b)
○ How to recharge USB device (Fig. 8)
○ When charging of USB device is completed (Fig. 9)
NAMES OF PARTS (Fig. 1–Fig. 13)
Handle
Regulator pressure gauge
Electric motor & air compressor pump
Quick coupler
Tank
Rubber foot
Drain valve
Power switch (Pressure switch inside)
Pressure regulator knob
Tank pressure gauge
Safety valve
Intake fi lter
Intake fi lter body
Filter element
Protrusions (× 3)
Grooves (× 3)
Battery
Latch
Head cover
Charger indicator lamp
Battery level indicator switch
Battery level indicator lamp
Display panel
Pneumatic tool (not included)
Male quick-connect plug
Air hose with quick coupler fi tting (not included)
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
EC36DA: Cordless Air Compressor
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
9
English