Publicidad
CAUTION
CAUTION
Thermo Scientific
Draining
Drain the bath before moving or storing.
Immediately clean up any spills on the floor to prevent a potential slip hazard.
Ensure the fluid is at a safe handling temperature, ~40°C or lower. Wear protective
clothing and gloves.
• Place a suitable receptacle underneath the drain.
• Slowly turn the drain plug until flow is observed.
• When the flow stops close the drain plug.
Optional Accessories
Only use the accessories supplied by Thermo Fisher.
Drain Kit Accessory
• Before filling the bath remove the drain plug from the bath drain.
• Wrap coupler with Teflon® tape, or equivalent, and install into bath drain.
• Insert quick disconnect into hose.
• Place the power switch to the 0 (off) position.
• Disconnect the power cord from the main power source.
• Insert the quick disconnect into the coupler until it clicks, ensuring that the drain hose is
positioned over the proper receptacle.
• When the reservoir is completely empty, press the button on the quick disconnect to release
the drain hose and pull free from the unit.
• Wipe the reservoir clean.
Neoprene Hose (3/8ID x 5/8OD)
Figure 3-2 – Drain Kit Accessory
(Catalog number 098246)
Coupler
Quick Disconnect
Installation | Section 3
Precision | 3-7
Publicidad
