Publicidad
Chapter 4
|
Operation
CAUTION
CAUTION
4-2
|
Precision
Start Up
Before starting, double check all electrical connections.
An operating Shaker Water Bath has moving components. Do not insert appendages
between the reservoir wall and rack. We recommend stopping the shaker table when
loading/removing samples or vessels.
Ensure all glass vessels are secure. Unrestrained vessels may shift and break when
shaking is engaged. Flask clips and trays are available from Thermo Fisher.
Do not run the bath until fluid is added to the reservoir. Have extra fluid on hand. If the bath does
not start refer to Chapter 6 Troubleshooting.
Place the circuit protector located on the rear of the bath to the I position.
•
•
The screen will momentarily display
the set point and the audible alarm status. The set point is the desired reservoir fluid temperature.
•
Press
to start the bath and display the reservoir fluid temperature. If the fluid
temperature is below the set point the heater will start.
29.9°C
30.0°C
and then the home screen appears displaying
30.0°C
Thermo Scientific
Publicidad
