HIKOKI CG 18DA Instrucciones De Manejo página 10

English
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
CG18DA(L):
Cordless Brush Cutter
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools that
have reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling facility.
Disconnect battery before maintenance
Always wear eye protection.
Always wear hearing protection.
Do not use a power tool in the rain and moisture
or leave it outdoors when it is raining.
Beware of thrown objects
The distance between the machine and
bystanders shall be at least 15 m (50 ft)
Wear head protection
Wear hand protection
Wear slip-resistant footwear
Beware of blade thrust
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Shows maximum shaft speed. Do not use the
Max
cutting attachment whose max rpm is below the
8,000 min-
1
shaft rpm.
Indicate handle location. Arrows which show
limits for handle positioning.
Direct current
V
Rated voltage
(Original instructions)
n
0
No-load speed
Switching ON
Switching OFF
Eco mode
Normal mode
Power mode
Power switch
Mode switch
Battery
Lights ;
The battery remaining power is over 75%.
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%.
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
WHAT IS WHAT?
The names of parts in the list below correspond to Fig. 1.
A: Lever: Trigger for activating the unit.
B: Lock lever: Lever that prevents the accidental operation
of the trigger.
C: Motor: Battery-driven motor.
D: Guard: Protects operator from flying debris.
E: Battery (sold separately): Power source to drive the
unit.
F: Power switch: Switch for switching the units power
unit's power ON or OFF.
G: Mode switch: Switch for adjusting the speed of the
motor.
H: Hanger: Used for attaching a shoulder belt to the unit.
I: Loop handle
J: Cutting attachment (Blade)
K: Shoulder belt: Harness with release mechanism.
L: Combi box spanner
10