HIKOKI CG 18DA Instrucciones De Manejo página 23

NOTE
Due to HiKOKI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult
your dealer or the HiKOKI Authorized Service Center.
Symptom
The tool does not function.
The tool starts, then stops soon.
The speed cannot be changed.
Vibration is excessive.
The blade does not cut well
Possible cause
The battery is dead.
The battery is not fully inserted.
The battery is overheated.
The power is not on.
The operator attempted to pull the
lever without pressing the lock lever.
Excessive vegetation entangled in
the guard and nylon head overloaded
the motor.
The battery is low.
The battery is overheated.
The tool is overloaded.
The battery is low.
The cutting attachment is not
correctly attached.
The cutting attachment is cracked,
broken, or deformed.
The handle is not securely attached
to the main pipe.
The guard is not securely attached to
the main pipe.
The tip of the blade is damaged
23
Remedy
Recharge the battery.
Pull out the battery and remove any
debris from the battery compartment.
Use cotton swabs or similar materials
to remove dirt or water from the
battery terminals.
Insert the battery firmly until it clicks
into place.
Stop using the tool. Remove the
battery and allow the battery to cool
in a shaded, well-ventilated area.
Press the power switch on the
housing.
The tool features an auto power off
function that turns the power off
automatically after one minute if the
operator does not operate the lever.
The tool will not allow operation of the
lever unless the operator presses the
lock lever to release the safety lock
mechanism.
Grasp the handle and press the lock
lever while pulling the lever.
If overloaded, the motor may cut out
to protect the tool and battery.
Turn off the power, remove the
battery, and clear the cause of the
overload.
The tool can be used again after
turning the power back on.
Recharge the battery.
Stop using the tool. Remove the
battery and allow the battery to cool
in a shaded, well-ventilated area.
Reduce the cutting depth to reduce
the load.
Recharge the battery.
Reattach the cutting attachment.
Replace the cutting attachment.
Attach securely.
Attach securely.
Replace the blade.
English