Tripp-Lite SmartOnline Single-Phase 5kVA Manual Del Propietário página 18

Power ON/OFF (5kVA models only)
1.To put UPS in BYPASS mode: Press and hold the OFF button
• Put the UPS in SETUP mode by holding down the SCROLL
• Scroll through setup options (using
SELECT button
a. Output Voltage: Select 200, 208, 220, 230 or 240V AC..
b. Output Frequency: Your UPS will auto-select 50 or 60 Hz to match the input.
c. Economy Mode: Your UPS can provide on-line operation with zero transfer-time. It can also operate in a more energy-
efficient, line-interactive mode. Select "Economy On" to put the UPS in line-interactive mode. Select "Economy Off" to put
the UPS in on-line mode.
• After you have set these options, exit the SETUP mode with the SCROLL button
C
the ON button
2. Turn input to the UPS ON: Press and hold the power module's ON button
mode. Note that some electronic equipment may draw more amps during startup; when starting from battery, consider reducing the initial
load on the UPS. Your UPS will perform a brief self-test and show the results on the LCD Display
"Operation" section for the display sequence.
3. To turn the UPS power module and transformer module (if used) OFF: Press the power module's OFF button
beep. Your load will still be energized. The inverter is now off, but your UPS is not fully deactivated. The LCD Display
BYPASS MODE. Turn the power module's Output Breaker
transformer module is used, unplug its connector cable from the power module. Your load will no longer be energized, and the LCD
Display D will be dark.
A B
or
B
.
until you hear the UPS beep once.
E
5kVA Models
F
until the UPS beeps once.
A
and SELECT
) and select the appropriate setting for each of the following options using the
C
until you hear a beep to start your UPS in ON BATTERY
E
OFF. Unplug the power module's AC input cord from the wall outlet. If a
18
B
buttons simultaneously.
A then exit BYPASS mode by holding down
D
. See "Startup Self-Test" in the
C A B
5kVA Models
(Front Panel)
F
until you hear a
D
will show
D
F